BMIL International
Bally Adapt-A-Door

Adapts to almost any Retrofit or Replacement

Shut the door on poor sealing, energy wasting and sticking. Install the Bally-Adapt-A-Door Now!
Bally Adapt-A-Door
36" x 78"
(914mm x 1981mm)

The versatile new Bally Adapt-A-Door puts an end to problems with replacement and retrofitting of doors for walk-in and refrigerated warehouses. Choose from three varieties that make it easy to replace a worn-out, or ill-fitting door in any walk-in or warehouse. Or use the Bally door for the easiest way to install a new door wherever you need it.

No matter what the application, Bally's Adapt-A-Door fits. You can use it with Bally's panel construction systems -- or with virtually any other panel or wall.

You can even cut this outstanding door into an ordinary masonry wall. In most replacement situations, the Adapt-A-Door is better than the original equipment!

Any way you see it, the Bally Adapt-A-Door will swing freely and seal tightly for years. The Adapt-A-Door comes in standard finishes of White over embossed galvanized Steel, Stainless Steel and Stucco Aluminum.

The door is supported by heavy duty hinges and comes with a durable latch assembly.

The same super-insulated poured-foam urethane that protects every Bally panel is foamed into the Adapt-A-Door. Like all Bally's urethane-insulated products, this door exceeds current CFC-reduction regulations stated in the Montreal Protocol. And it's easy to install - anywhere you need it.

Available sizes range from:

  •  24", 30", 34", 36" 42", 48" and 60" Widths and from 66" to 84" Heights.
  • 609mm, 762mm, 864mm, 914mm, 1067mm, 1219mm and 1524mm widths and from 1676mm to 2134mm Heights

Shown with optional Kick-Plate and Locking Bar

Three Types to Fit Your Specific Needs!

Type 1:

Cooler Door with 3-Sided Frame Loop Heaters in Frame, and Heaters in Door Cap. Use with new construction and replacement on any floorless cooler.

Type 2:

Freezer Door with 3-Sided Frame. Same and Type 1, but with additional heater and gasket supplied at bottom of door. Use for retrofit or replacement on any floorless freezer.

Type 3:

Cooler/Freezer Door with 4-Sided Frame. Heat and Gasketing around perimeter of Door and Frame. Use for applications with raised insulated floor -- new, retrofit or replacement.

Standard Features:

  • Rugged Douglas Fir Frame Specially Treated to Resists Moisture.
  • Anti-Condensate Heaters to Prevent Moisture or Ice Buildup.
  • Poured-Foam Urethane Insulation.
  • Proven Durable Positive Magnetic Gasket Seal.
  • Variety of Standard Finishes - White over Embossed Galvanized, Aluminum, Stainless Steel.
  • Right- or Left-Hand Swing (right-hand swing shown above)
  • Heavy-Duty Hinges and Latch Assemblies.
  • Mounting Kit.
  • Options Include:
    Observation Window
    Diamond Plate Protection
    Locking Bar

Typical Section Thru Width
Typical Section Thru Width

Section Thru Alternate Jambs




BMIL International


Contact Us

  Copyright 2009, BMIL Technologies, LLC., Inc. All rights reserved
4915 Arendell St., #313, Morehead City, NC 28557, (212) 898-9699
Names and Logos are registered Trademarks of their respective companies.

Send comments on this web site to Last revised: September 27, 2012